Georgetown Well Drilling: Water Well Drilling in Georgetown, TX
Georgetown Well Drilling is a licensed and insured Texas water well contractor serving rural and acreage property across Georgetown, Liberty Hill, and Williamson County. We drill new wells, deepen wells that a drought pulled down, replace pumps and pressure tanks, and plug old wells to code. Our customers are people building on raw land past the city main, owners whose well finally quit, and buyers who need to know what a well really does before they close.
In this county the ground makes the call. West and north of town the Trinity runs deep, so a well is a real drilling job; toward the Edwards limestone the water comes shallower but the yield swings from lot to lot. We read the nearby wells, drill to a sound producing zone, and price the well off the depth we actually reach, not off a number over the phone.
Call for a Free Estimate- Licensed and insured Texas water well contractor
- New wells drilled, cased, and completed
- Well deepening and drought re-drills
- Pump, pressure tank, and storage systems
- Central Texas GCD permitting handled
Water Well Drilling
A new well is what makes raw land livable. We read the ground, permit the well with the groundwater district, drill to a sound zone, and case the hole to hold the wall and keep surface water out.
The whole job runs through us: drilling, casing, pump, pressure tank, wiring, and the water test that finishes it. More on water well drilling.
Well Deepening and Re-Drill
When a well sputters in a dry summer, the water table dropped below the pump or the pump failed. Those two problems look the same at the tap and cost very different money. We measure before we quote.
The fix is a lower pump, a deeper hole, or a new well, cheapest first. More on deepening and re-drill.
Pump Replacement and Repair
No water and low pressure are year-round problems, not just drought ones. A submersible pump, a pressure switch, a waterlogged tank, or bad wiring can each kill the flow. We test the whole system and fix the part that actually failed.
We diagnose the above-ground parts first, so if the fix is up top you never pay to pull the well. More on pump service.
Pressure Tanks and Storage
The pump gets water out of the ground; the pressure tank and storage turn it into steady pressure in the house. A slow Edwards well that cannot serve the home directly can still fill a storage tank all day and deliver full pressure through a booster.
We size the tank to the pump, so the pump lasts and the pressure holds. More on tanks and storage.
Well Inspection and Water Testing
A private well has no utility watching it. Before you buy an acreage home, you want to know what the well produces, what shape the pump is in, and whether the water is safe. Those facts belong on your side of the table before closing.
We run a flow test, check the whole system, and pull a sample for a certified lab. More on inspection and testing.
Well Plugging and Abandonment
An old, unused well is an open pipe into the aquifer and a hazard on the surface. Texas rules make sealing it the owner's responsibility, and it has to be done by a licensed driller.
We fill the borehole with grout from the bottom up and file the plugging report. More on plugging and abandonment.
Why Williamson County Owners Call Us
- We read the ground before we quote. Trinity or Edwards, deep or shallow, the aquifer under your lot sets the depth and the depth sets the price. A number given before that is a guess. Start with water well drilling.
- We diagnose before we pull a pump. Half of no-water calls are an above-ground part, not the submersible. We test those first and save you the cost of pulling the well. See pump service.
- We measure a dry well before we sell you a deeper one. If the water is still there and the pump sits too high, lowering it fixes the well for far less. See deepening and re-drill.
- We make slow wells work. A low-yield Edwards well plus storage and a booster serves a household the well could never handle on demand. See pressure tanks and storage.
- We handle the district, not just the drilling. Every well is permitted and registered through the Central Texas Groundwater Conservation District, so it stands up at inspection and at resale.
- We seal what we retire. When a well is done, we plug it to code and file the report. See plugging and abandonment.
How a Water Well Actually Works
Most people never think about where their water comes from until it stops. A private well is a simple idea done carefully, and understanding it explains every cost and every rule that comes with one.
Drill, Case, and Seal
A rig drills a hole down to a water-bearing zone in the rock. Steel or PVC casing lines the hole to hold the wall and, just as important, to seal the upper section so surface water and contamination cannot run down the outside of the pipe into your drinking water. A well is only as safe as its casing and its seal.
The Pump Does the Lifting
A submersible pump sits near the bottom of the well, under the water, and pushes it up to the house. Set it too high and a dry summer leaves it sucking air; set it right and it stays under water through the season. The pump is the part that fails most, and matching it to the well depth and the household demand is what makes it last.
The Pressure Tank Holds the Cushion
The pump does not run every time you open a tap. A pressure tank stores a cushion of pressurized air so you can draw water between pump cycles. When that cushion fails, the pump kicks on for every cup and burns itself out. A healthy pressure tank is what keeps a pump alive for years.
What a Well Needs From You
A yearly water test, because no utility is checking it for you. Attention to pressure changes, which are the well's early warning. And, when it finally ages out, a proper plugging, because an abandoned well left open is a problem for the aquifer and the next owner both. A watched well serves a home for decades.
How a New Well Comes In
Read the Ground
We look at the nearby wells, the aquifer under your lot, and how deep the water is likely to be, so the plan fits the ground and not a template.
Permit the Well
We file with the Central Texas Groundwater Conservation District and hold the spacing from lines, septic, and other wells before a bit turns.
Drill and Case
The rig drills to a sound producing zone. We case the hole to hold the wall and seal out surface water, to the depth the ground actually gives.
Set Pump and Tank
We set the pump deep enough to stay under water, plumb the pressure tank or storage, and wire the controls that protect the pump.
Test and Register
We flow-test the well, sample the water, and register the completed well with the district so the record is clean at resale.
What Moves the Price of a Water Well
Nobody can quote a well over the phone, and any site that prints one number for your county is guessing. On current Central Texas jobs, a complete home well runs roughly eight thousand into the thirty thousand range, and where a job lands in that spread comes down to a short list of things.
Depth leads it, by a mile. A shallow Edwards well that hits water under three hundred feet costs far less to reach than a deep Trinity well that needs hundreds of feet of drilling and casing. Which aquifer your land taps is the single biggest factor.
Casing is next. The deeper the well and the looser the rock, the more casing it takes to hold the hole and seal it. Casing is material and labor both, and it scales with depth.
Then the completion and the site:
- Pump size, set by well depth and household demand
- Whether a slow well needs storage and a booster to keep up
- The run of the power and the plumbing to the house
- Access for the rig and how far material is hauled
- Whether an old well has to be plugged first
- The water zone's yield, which no one knows for certain until we drill
This is why we read the ground before we write a number. A quote given before anyone knows the target depth is a guess wearing a letterhead.
Frequently Asked Questions
How much does a water well cost around Georgetown?
On current Central Texas jobs, a complete home well, meaning the drilling, casing, pump, pressure tank, and wiring, commonly runs from roughly eight thousand into the thirty thousand range. Depth drives most of it. A shallow Edwards well costs far less to reach than a deep Trinity well. We price the well after we know the target depth, because a number given before that is a guess.
How deep will my well have to be?
It depends on which aquifer your land sits over. West and north of Georgetown many wells draw from the Trinity and run from about 400 to past 800 feet. Toward the Edwards limestone water can come shallower, sometimes under 300 feet, but the yield is less predictable. We look at the nearby wells and drill to the water the ground actually gives, rather than guessing your depth from a table.
Do I need a permit to drill a well?
Yes. Most of Williamson County sits inside the Central Texas Groundwater Conservation District, and a new well there needs a permit and a registered driller before a bit turns. The district sets spacing from lines and other wells and registers the well when it is done. We are a licensed Texas driller, we file the permit, and we drill to the district rules.
My well went dry in the drought. Is it really dry?
Maybe, and maybe not. A dropping water table and a failing pump produce the same sputtering faucet. We measure the standing water level and the pump depth before we quote. If the water is still there and the pump sits too high, lowering it fixes the well for a fraction of the cost of a deeper hole. We only drill deeper when the water itself has fallen past the well.
Can you work on a well you did not drill?
Yes. Most of our pump and repair work is on wells someone else drilled, often decades ago. We pull whatever is down there, match a new pump to the well depth and demand, and replace worn drop pipe and wire while the well is open. You get a well that runs and a clear picture of what is actually in the ground.
What about the old well already on my land?
Check it before you build over it or forget it. We see whether it can be reused, and if not, we plug it to state and district code and file the report. An open, abandoned well is a path for contamination into the aquifer and a liability that follows the property. Sealing it correctly closes that.
Should I test my well water?
Yes. A yearly bacteria test is the standard for any household well, plus a test any time the water changes in taste, smell, or color, and after a flood. A private well has no utility watching the water for you, so the testing is on the owner. We pull the sample properly and send it to a certified lab.
How long from first call to running water?
The drilling and casing on a typical home well is one to three days once the rig is on site. Ahead of that sit the permit, the rig schedule, and the pump and tank set. Plan for a few weeks from first call to running water, more in a busy season. We give you the real timeline for your lot, not a number meant to win the job.
Two Aquifers, One County
Williamson County hands a driller a split personality. The line between the Edwards and the Trinity runs right through it, and which side your land falls on decides how a well gets built and what it costs.
Toward the Edwards limestone on the west, water moves through fractures and caves in the rock. A well can catch it shallow, which sounds like good news, but the yield is unpredictable and swings from one lot to the next. A well in fractured Edwards may need storage to serve a house, because a slow well cannot meet a shower and a washer at once on its own. The rock giveth quickly and unevenly.
North, east, and deeper, the Trinity takes over. Trinity wells drill deep and carry real casing, so they cost more up front, but they tend to be steadier producers that ride out a drought better than a thin Edwards well. On the Trinity, the money goes into depth and casing, and what you buy is reliability.
The last piece is growth. Austin keeps pushing north into Williamson County, and homes keep landing on acreage past the end of the mains. That gives this market both kinds of work at once: first wells on new tracts, and drought repairs on the older wells already in the ground. Both start the same way, with somebody reading what the ground under that particular lot will give.
Water Well Service Across Williamson County
We drill and service wells across Williamson County and its acreage edges. The mains stop at the city lines, and everything past them runs on a private well. That covers Liberty Hill and Leander on the Hill Country side, Cedar Park and Round Rock along the corridor, Hutto and Taylor out on the blackland, and Jarrell and Florence to the north.
Ready to Get Your Land Read?
Call (512) 555-0148 for a free estimate. Tell us where the land is, whether you are drilling a first well or fixing one that quit, how many people and how much irrigation the well has to serve, and whether there is an old well on the property. We will tell you straight whether you are looking at a new well, a deeper hole, a pump, or just a lower pump, and what the ground has to settle before anybody can price it.